Beko CDA 664 F Guida alla Risoluzione dei Problemi Scaricare il pdf (Pagina 8)

8 | BEKO TECHNOLOGIES GMBH

5. Connecting the pre-filter to the dryer

1. Connect filter and DRYPOINT AC using proper sealing material and the fittings

supplied.

2. If you are using the integrated

condensate drain: Connect condensate

outlet of filet with the condensate inlet

on the back side of the dryer, using the

tube supplied (4mm) diameter. Apply

another discharge tube from the

condensate outlet on the back side of

the dryer into an oil water separator.

If you are using a BEKOMAT 20FM

condensate drain: Apply a discharge tube

from the condensate drain outlet of the

BEKOMAT 20FM into an oil water

separator.

All tubing should be secured up to the point

of drain to prevent whipping during discharge.

5.1 Recommendation

It is recommended that a bypass line including filter (not supplied) is installed.

Figure 5.1

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Nessun commento

Beko CDA 664 F Guida alla Risoluzione dei Problemi Pagina 8